1.5" Injection Cap 3/4" F-NPT

ECT Mfg., Inc.

2.25" Injection Cap w/ 1" F-NPT

ECT's 2.25" Injection Cap with 1" F-NPT was designed to fit your 2.25" Geoprobe Rod. The 1" Female NPT thread can be used to set up a quick-connect hose for your injection pump.

ECT Mfg., Inc.

1.5" Grout/Injection Pull Cap

1.5" Grout/Injection Pull Cap with 3/4" NPT Side Port

Geoprobe®

1.5″ Grout/Injection Pull Cap, Geoprobe®

Call for Price

1.5″ Grout/Injection Pull Cap, Geoprobe®

ECT Mfg., Inc.

1.5″ Injection Check Valve

The 1-1/2" Injection Check Valve attaches to your 1.5" Geoprobe Rod. The main feature of this probe is that it prevents remediation back-flow, keeping injection material in the ground and not on the...

ECT Mfg., Inc.

1.5" Retractable Injection Tool

Call for Price

ECT’s 1.5″ OD “Retractable” Injection Tool is driven to the target depth using 1.5″ Probe Rods. The rods are then retracted to expose the 24″ section of injection ports. The upper and lower halves of...

ECT Mfg., Inc.

1.5" Slip Cap

2" PVC Slip Cap will fit both Sch40 and Sch80 PVC

Geoprobe®

1.5″ Pressure Activated Injection Probe, Geoprobe®

Call for Price

1.5" Pressure Activated Injection Probe (4 x 1/4" Ports) Geoprobe®

Geoprobe®

2.25″ Injection Pull Cap, Geoprobe®

Call for Price

The 2.25" Injection Pull Cap is on a swivel that adds a flange and allows pulling of the tool string during bottom-up injection. There is an O-ring that creates a watertight seal. The grout pump can...

ECT Mfg., Inc.

1.5" Threaded Cap / Plug

8 TPI

1.5" Injection Molded Well Flats. Male Plugs and Female Caps 8 TPI. Molded from Prime Virgin PVCInjected molded for consistent guaranteed thread tolerances every timeEasy tightening grip tabs make...